The instrument package SEIS (Seismic Experiment for Internal Structure) with the three very broadband and three short-period seismic sensors is installed on the surface on Mars as part of NASA’s InSight Discovery mission. When compared to terrestrial installations, SEIS is deployed in a very harsh wind and temperature environment that leads to inevitable degradation of the quality of the recorded data. One ubiquitous artifact in the raw data is an abundance of transient one-sided pulses often accompanied by high-frequency spikes. These pulses, which we term “glitches”, can be modeled as the response of the instrument to a step in acceleration, while the spikes can be modeled as the response to a simultaneous step in displacement. We attribute the glitches primarily to SEIS-internal stress relaxations caused by the large temperature variations to which the instrument is exposed during a Martian day. Only a small fraction of glitches correspond to a motion of the SEIS package as a whole caused by minuscule tilts of either the instrument or the ground. In this study, we focus on the analysis of the glitch+spike phenomenon and present how these signals can be automatically detected and removed from SEIS’ raw data. As glitches affect many standard seismological analysis methods such as receiver functions, spectral decomposition and source inversions, we anticipate that studies of the Martian seismicity as well as studies of Mars’ internal structure should benefit from deglitched seismic data.

Seismic noise recorded at the surface of Mars has been monitored since February 2019, using the seismometers of the InSight lander. The noise on Mars is 500 times lower than on Earth at night and it increases during the day. We analyze its polarization as a function of time and frequency in the band 0.03-1Hz. We use the degree of polarization to extract signals with stable polarization whatever their amplitude. We detect polarized signals at all frequencies and all times. Glitches correspond to linear polarized signals which are more abundant during the night. For signals with elliptical polarization, the ellipse is in the horizontal plane with clockwise and anti-clockwise motion at low frequency (LF). At high frequency (HF), the ellipse is in the vertical plane and the major axis is tilted with respect to the vertical. Whereas polarization azimuths are different in the two frequency bands, they are both varying as a function of local time and season. They are also correlated with wind direction, particularly during the day. We investigate possible aseismic and seismic origin of the polarized signals. Lander or tether noise are discarded. Pressure fluctuation transported by environmmental wind may explain part of the HF polarization but not the tilt of the ellipse. This tilt can be obtained if the source is an acoustic emission in some particular case. Finally, in the evening when the wind is low, the measured polarized signals seems to correspond to a diffuse seismic wavefield that would be the Mars microseismic noise.

The SEIS seismometer of the InSight mission was deployed on the ground of Elysium Planitia, on 19 December 2018. Interferometry techniques can be used to extract information on the internal structure from the autocorrelation of seismic ambient noise and coda of seismic events. In a single-station configuration, the zero-offset global reflection of the ground vertically below the seismometer can be approximated by the stacked ZZ autocorrelation function (ACF) for P-waves and the stacked EE and NN ACFs for S-waves, assuming a horizontally layered medium and homogeneously distributed and mutually uncorrelated noise sources. We analyze continuous records from the very broadband seismometer (SEIS-VBB), and correct for potential environmental disturbances through systematic preprocessing. For each Sol (martian day), we computed the correlations functions in 24 windows of one martian hour in order to obtain a total correlation tensor for various Mars local times. In addition, a similar algorithm is applied to the Marsquake waveforms in different frequency bands. Both stability analysis and inter-comparison between background noise and seismic event results suggest that the background seismic noise at the landing site is reliably observed only around 2.4 Hz, where an unknown mechanism is amplifying the ground shaking, and only during early night hours, when the noise induced by atmospheric disturbances is minimum. Seismic energy arrivals are consistently observed across the various data-sets. Some of these arrivals present multiples. These observations are discussed in terms of Mars’ crustal structure.