loading page

Influence of processing parameters of selective laser melting on high-cycle and very-high-cycle fatigue behavior of Ti-6Al-4V
  • +1
  • Leiming Du,
  • Guian Qian,
  • Liang Zheng,
  • Youshi Hong
Leiming Du
Chinese Academy of Sciences Institute of Mechanics

Corresponding Author:[email protected]

Author Profile
Guian Qian
Institute of Mechanics Chinese Academy of Sciences
Author Profile
Liang Zheng
School of Science, Harbin Institute of Technology
Author Profile
Youshi Hong
Institute of Mechanics, Chinese Academy of Sciences
Author Profile


Orthogonal experiment design together with the analysis of variance was used to examine the processing parameters (laser power, scan speed, layer thickness and hatch spacing) of selective laser melting (SLM) for superior properties of SLM parts, in which nine groups of specimens of Ti-6Al-4V were fabricated. The porosity for each group was measured and the results clarify that the influence sequence of individual parameter on the porosity is laser power > hatch spacing > layer thickness > scan speed. Ultrasonic fatigue tests (20 kHz) were conducted for the SLMed specimens in high-cycle fatigue (HCF) and very-high-cycle fatigue (VHCF) regimes. The S-N data show that the fatigue strength is greatly affected by the porosity: the group with the smallest porosity percentage having the highest fatigue strength in HCF and VHCF regimes. Moreover, the observations by scanning electron microscopy revealed that fatigue cracks initiate at lack-of-fusion defects in the cases of surface and internal crack initiation.
04 Jul 2020Submitted to Fatigue & Fracture of Engineering Materials & Structures
04 Jul 2020Submission Checks Completed
04 Jul 2020Assigned to Editor
17 Jul 2020Reviewer(s) Assigned
08 Aug 2020Review(s) Completed, Editorial Evaluation Pending
08 Aug 2020Editorial Decision: Revise Minor
06 Sep 20201st Revision Received
07 Sep 2020Submission Checks Completed
07 Sep 2020Assigned to Editor
07 Sep 2020Reviewer(s) Assigned
13 Sep 2020Review(s) Completed, Editorial Evaluation Pending
15 Sep 2020Editorial Decision: Accept