deletions | additions       diff --git a/Figures.tex b/Figures.tex  index 5bae8ce..457c6fd 100644  --- a/Figures.tex  +++ b/Figures.tex 
...
\subsection{Neon Experiment}   Using Fig.  \ref{fig:NeonAnalysis} and Eq. \ref{eq:lowestlevel}, we plugged in x to be 0.5 to find the excitation level for each of the linear fits shown in the plot. This generated an excitation energy of $19.4993 \pm 0.6$ eV. This has to be the first excitation level because we derived Eq. \ref{eq:lowestlevel} by setting $E_a$ equal to the lowest energy level. However, this is not consistent with the first excitation energy level shown on the NIST website (Fig. \ref{fig:NeonEnergyLevels}). However, this inconsistent value could be due to the high voltage preamp damage after the failure to make a connection between the filament and accelerating voltage. In our experiment, we debugged our system and found that the gain of the high voltage supply was actually times 17V instead of 20V. After compensating for the true gain, we found the excitation level of neon to occur around $16.66 \pm 0.51$ eV. This value is much closer to the first excitation level of neon according the the NIST website. \\ %actually Eq1. only assumes that Ea corresponds to the difference between two energy levels in the Ne atom. It doesn’t have to be the first excitation level, but would normally be so if collisions are very frequent. There are Ne energy levels in the 19.5 ± 0.6 eV range. In this case, however, this could be due to I think this could be because after the damage done to the HV preamp after the failure to include a connection between the filament and the accelerating voltage, the gain was only x17 rather than x20. So then you would think the energy difference was 19.5 V, but it would really be (17/20)(19.5) = 16.6 V.