this is for holding javascript data
Lucy Liang edited Table_ref_table_shot_noise_shows__1.tex
over 8 years ago
Commit id: 6f2b1ed95b2456bcebf0475c73e476a98e76bfa1
deletions | additions
diff --git a/Table_ref_table_shot_noise_shows__1.tex b/Table_ref_table_shot_noise_shows__1.tex
index 31944ba..6ecc08e 100644
--- a/Table_ref_table_shot_noise_shows__1.tex
+++ b/Table_ref_table_shot_noise_shows__1.tex
...
Table \ref{table:shot_noise} shows the values obtained from performing the Shot Noise Experiment, where
V $V$ across the Photodiode was the measured voltage across the photo-diode, and the Noise is Photodiode is the noise in the voltage measurement across the photo-diode, $V_{sq}$ was the measured squared voltage from the multimeter and the noise in $V_{sq}$ is the noise in the squared voltage. Table \ref{table:shot_noise} shows the data obtained from the multi-meter, the values before they were converted to current as we wanted to show the values expected from the apparatus. To convert to current you use Ohm's Law: $V=IR$ where, in this case, $R$ is $10 k\Omega$ and the $V$ are the values found from the multi-meter (Table \ref{table:shot_noise}).