this is for holding javascript data
Madeline Horn edited textit_Johnson_Noise_To_perform__.tex
over 8 years ago
Commit id: 5354ea42d0eb343d873e6cb4da08de54ba0e016c
deletions | additions
diff --git a/textit_Johnson_Noise_To_perform__.tex b/textit_Johnson_Noise_To_perform__.tex
index bd7ae2b..583ac70 100644
--- a/textit_Johnson_Noise_To_perform__.tex
+++ b/textit_Johnson_Noise_To_perform__.tex
...
\textit{Johnson Noise}
To perform the Johnson Noise Experiment, we used the Noise Fundamentals devices and two digital multi-meters. Our settings for the Noise Fundamentals devices were as follows: $10K$ ohm resistor, we used a Gain 1 (G1) of $600$
for all values that comes directly from the Noise Fundamental device, a Gain 2 (G2) of $1000$ for all values, we used a room temperature of $295$ degrees Kelvin, and we varied the high and low pass filters' frequency for each data set in order to vary the bandwidth. In Table 1, you can see how we varied the low pass filter (f2) and the high pass filter (f1) in order to change the bandwidth. The values are taken from the multi-meter after going through the filters, gain, and multiplier. All of the values are in mV; we took $36$ sets of data points.