deletions | additions       diff --git a/layout.md b/layout.md  index 51a1d48..163c8cf 100644  --- a/layout.md  +++ b/layout.md 
...
figures/Screen Shot 2015-12-22 at 2.55.32 PM/Screen Shot 2015-12-22 at 2.55.32 PM.png  figures/Screen Shot 2015-12-22 at 2.55.57 PM/Screen Shot 2015-12-22 at 2.55.57 PM.png  figures/IMG_1/IMG_1.png  subsubsection_Johnson_noise_for_the__.tex  Table_ref_table_Johnson1_shows__.tex  begin_table_label_table_Johnson1__.tex  subsubsection_Johnson_noise_in_1k__.tex  diff --git a/subsubsection_Johnson_noise_for_the__.tex b/subsubsection_Johnson_noise_for_the__.tex  deleted file mode 100644  index f8bbed2..0000000  --- a/subsubsection_Johnson_noise_for_the__.tex  +++ /dev/null 
...
\subsubsection{Johnson noise for the $10k \Omega$ Resistor}  Refer to electronics setup photo Fig.~\ref{fig:JohnsonSetUp} for the set up of our apparatus. Our settings for the Noise Fundamentals devices were as follows: for the $10\textrm{k}\Omega$ resistor, we used a Gain 1 ($G1$) of $\times600$ for all values that comes directly from the Noise Fundamental device, a Gain 2 ($G2$) of $\times1000$ for all values, we used a measured value for room temperature of $295$ degrees Kelvin, and we varied the high and low pass filters' frequency for each data set in order to vary the bandwidth. In Table \ref{table:Johnson1}, you can see how we varied the low pass filter ($f2$) and the high pass filter ($f1$) in order to change the bandwidth. The values are taken from the multi-meter after going through the filters, gain, and multiplier. All of the values are in mV; we took $36$ sets of data points. You can see all these values in Table \ref{table:Johnson1}