this is for holding javascript data
Madeline Horn added subsection_Noise_Trial_Our_settings__.tex
over 8 years ago
Commit id: 281c681edf32a118dcd567c3aafb9f61c162b717
deletions | additions
diff --git a/subsection_Noise_Trial_Our_settings__.tex b/subsection_Noise_Trial_Our_settings__.tex
new file mode 100644
index 0000000..960de01
--- /dev/null
+++ b/subsection_Noise_Trial_Our_settings__.tex
...
\subsection{Noise Trial}
Our settings for the Noise Fundamentals devices were as follows: $1$ ohm resistor, we used a Gain 1 (G1) of $600$ for all values that comes directly from the Noise Fundamental device, a Gain 2 (G2) of $1000$ for all values, we used a room temperature of $296.15$ degrees Kelvin, and we varied the high and low pass filters' frequency for each data set in order to vary the bandwidth. In Table 1, you can see how we varied the low pass filter (f2) and the high pass filter (f1) in order to change the bandwidth. The values are taken from the multi-meter after going through the filters, gain, and multiplier. All of the values are in mV; we took $36$ sets of data points. You can see all these values in Table 3.
