this is for holding javascript data
Madeline Horn edited subsubsection_Johnson_noise_for_the__1.tex
over 8 years ago
Commit id: 207ae512bd7dd10b6e5415557fd2cb4cde7a5f6c
deletions | additions
diff --git a/subsubsection_Johnson_noise_for_the__1.tex b/subsubsection_Johnson_noise_for_the__1.tex
index f8bbed2..a50768f 100644
--- a/subsubsection_Johnson_noise_for_the__1.tex
+++ b/subsubsection_Johnson_noise_for_the__1.tex
...
\subsubsection{Johnson noise for the $10k \Omega$ Resistor}
Refer to electronics setup photo Fig.~\ref{fig:JohnsonSetUp} for the set up of our apparatus. Our settings for the Noise Fundamentals devices were as follows: for the $10\textrm{k}\Omega$ resistor, we used a Gain 1 ($G1$) of $\times600$ for all values that comes directly from the Noise Fundamental device, a Gain 2 ($G2$) of $\times1000$ for all values, we used a measured value for room temperature of $295$ degrees Kelvin, and we varied the high and low pass filters' frequency
($\Delta f$) for each data set in order to vary the bandwidth. In Table \ref{table:Johnson1}, you can see how we varied the low pass filter ($f2$) and the high pass filter ($f1$) in order to change the bandwidth. The values are taken from the multi-meter after going through the filters, gain, and multiplier. All of the values are in mV; we took $36$ sets of data points. You can see all these values in Table \ref{table:Johnson1}