this is for holding javascript data
Sgt. Samuel H. Buckstein deleted file Circuits Improvement.tex
about 10 years ago
Commit id: 7782c55e71f58ec85dfe1194541ef82be3b27ba5
deletions | additions
diff --git a/Circuits Improvement.tex b/Circuits Improvement.tex
deleted file mode 100644
index 4a21326..0000000
--- a/Circuits Improvement.tex
+++ /dev/null
...
\subsubsection{Power Supply Network}
The device is powered by a MIOS 480W ATX computer power supply, which provides the PIC with 12V at 1A, the servo motors with 5V at 22A (!), and 5V at 2A which powers everything else, including the IR sensor board, the yellow sensor board, the stepper motor driver board, and the steppers themselves \cite{LazarRozenblat:2013}. A separate power and ground wire is run to each subsystem, and the wires converge immediately before the power supply. The wires from the power supply carrying 5V at 2 and 22A respectively first pass through the emergency cut-off switch, allowing for the immediate halt of current flow to all components of the device except for the PIC and illumination LEDs. These components do not move, and are powered by extremely low current, therefore these remaining live wire does not pose a risk. A full outline of the circuitry of the device can be seen in figure [INSERT FIGURE].
