this is for holding javascript data
Russell Neches added Printing the test part.tex
over 10 years ago
Commit id: 907e28cc18d34178151f817d7620d098d0a0c516
deletions | additions
diff --git a/Printing the test part.tex b/Printing the test part.tex
new file mode 100644
index 0000000..aa0d6a4
--- /dev/null
+++ b/Printing the test part.tex
...
The G-code was stored on a SD card and printed on an Ultimaker kit-based
FDM 3D printer. A small patch of aluminum foil was lightly abraded with
fine-grit sandpaper to improve surface ashesion properties, and flamed
over a Bunsen burner until signs of melting appeard. The foil patch was
then affixed to the build platform, so that the build area indicated in
the G-code toolpath would be entirely within the untouched center of the
patch. The G-code toolpath was also examined to insure that the nozzle
would contact no surface except the build are on the foil. Printing was
then initiated with a feed rate was 50 mm/sec at $220\,^{\circ}\mathrm{C}$.
