this is for holding javascript data
Michael Bieler edited sectionDEFINING_PRIM.tex
over 8 years ago
Commit id: c61fff7df104a9aeb8953e9413ba838ac266a1cd
deletions | additions
diff --git a/sectionDEFINING_PRIM.tex b/sectionDEFINING_PRIM.tex
index 9e5f8b1..4516c8b 100644
--- a/sectionDEFINING_PRIM.tex
+++ b/sectionDEFINING_PRIM.tex
...
\subsection{Low-beam-current}
This failure mode starts when the beam current drops below $I_{\hbox{tol}}$, but only if the machine
is not in the ``no-beam''
failures failure mode (otherwise all ``no-beam'' failures would be ``low-beam-current'' failures as well).
The ``low-beam-current'' failure stops when the beam current reaches the nominal beam current $I_{\hbox{nom}}$ again.
For facilities in top-up mode the current limit $I_{\hbox{tol}}$ should be slightly
below the current to start top-up injections.
...
\subsection{Primary Failure Modes in Practice}
Table~\ref{tab:pf-limits} shows the current limits for the primary
failure modes, partly depending on the operation modes
of at the seven facilities.
The column $I_{\hbox{nom}}$ shows the maximum current in the given operation mode.
The current $I_{\hbox{inj}}$ is the typical value when injection would start in this operation mode,
below $I_{\hbox{tol}}$ it would be considered a ``low-beam-current'' failure.