this is for holding javascript data
Kathryn Devine edited sectionResults_Eight.tex
over 8 years ago
Commit id: 90b0320ced5fe4f73a0a810aa898e7bfde8aa9b1
deletions | additions
diff --git a/sectionResults_Eight.tex b/sectionResults_Eight.tex
index fd74a65..5dcda03 100644
--- a/sectionResults_Eight.tex
+++ b/sectionResults_Eight.tex
...
\section{Results}
\subsection{CS Point Sources}
Eighteen sources displayed emission greater than 3$\sigma$. A typical spectrum is shown in Figure \ref{N92spectrum}. Emission lines were fit using fitgauss, the standard Gaussian fitting routine in GBTIDL. Fitting parameters (amplitude in T$_{mb}$ units, central velocity and FWHM) are listed in Table \ref{fitting}. For sources that displayed a double peak, two simultaneous Gaussian functions were fit to the emission and are listed in consecutive rows. {\bf CS column}
densities densities, {\bf \begin{math} N_{CS} \end{math}} were calculated assuming LTE, optically thin emission and an excitation temperature T$_{ex}$=15 K, a typical ISM value (see review in \citet{Zinnecker2007}). Increasing or decreasing the assumed excitation temperature by 5 K changes the column density by about 30\%. If CS(1-0) is optically thick, as we assume for three sources in section 4.2 below, then our calculation would be a lower limit. Given these assumptions we used the following relation (see \citet{Miettinen2012} for a detailed discussion of the relations below):
\begin{equation*}
N_{CS} = \frac{3 k_B \epsilon_0}{2 \pi^2}\frac{1}{\nu \mu^2_{el}S}\frac{Z_{rot}(T_{ex})}{g_K g_I}\frac{e^{E_u/k_B T_{ex}}}{1-\frac{F(T_{bg})}{F(T_{ex})}}\int T_{MB}dv