Top-down estimates of CO2 fluxes are typically constrained by either surface-based or space-based CO2 observations. Both of these measurement types have spatial and temporal gaps in observational coverage that can lead to biases in inferred fluxes. Assimilating both surface-based and space-based measurements concurrently in a flux inversion framework improves observational coverage and reduces sampling biases. This study examines the consistency of flux constraints provided by these different observations and the potential to combine them by performing a series of six-year (2010–2015) CO2 flux inversions. Flux inversions are performed assimilating surface-based measurements from the in situ and flask network, measurements from the Total Carbon Column Observing Network (TCCON), and space-based measurements from the Greenhouse Gases Observing Satellite (GOSAT), or all three datasets combined. Combining the datasets results in more precise flux estimates for sub-continental regions relative to any of the datasets alone. Combining the datasets also improves the accuracy of the posterior fluxes, based on reduced root-mean-square differences between posterior-flux-simulated CO2 and aircraft-based CO2 over midlatitude regions (0.35–0.50~ppm) in comparison to GOSAT (0.39–0.57~ppm), TCCON (0.52–0.63~ppm), or in situ and flask measurements (0.45–0.53~ppm) alone. These results suggest that surface-based and GOSAT measurements give complementary constraints on CO2 fluxes in the northern extratropics and can be combined in flux inversions to improve observational coverage. This stands in contrast with many earlier attempts to combine these datasets and suggests that improvements in the NASA Atmospheric CO2 Observations from Space (ACOS) retrieval algorithm have significantly improved the consistency of space-based and surface-based flux constraints.
2019 was both the hottest and driest year on record for Australia, leading to large forest fires in the southeast from November 2019 to January 2020. However, in early 2020, the fires and hot-dry conditions dissipated with above average rainfall and below average temperatures along Australia’s southeast coast. In this study, we utilize space-based measurements of trace gases (TROPOMI XCO, OCO-2 XCO2) and vegetation function (OCO-2 SIF, MODIS NDVI) to quantify the carbon cycle anomalies resulting from drought and fire in southeast Australia during the 2019/2020 growing season. During the austral spring, we find anomalous reductions in primary productivity and large biomass burning emissions in excess of bottom-up estimates from GFAS. This is then followed by a remarkable recovery and greening during early 2020, coincident with cooler and wetter conditions. We will further discuss different behaviors of recovery over fire-devasted and non-fire regions. This study showcases the capability of combining observations from multiple satellites to monitor the carbon and ecosystem anomalies resulting from extreme events. Finally, we will discuss the remaining challenges in monitoring the carbon cycle from space.
TanSat is the 1st Chinese carbon dioxide (CO) measurement satellite, launched in 2016. In this study, the University of Leicester Full Physics (UoL-FP) algorithm is implemented for TanSat nadir mode XCO retrievals. We develop a spectrum correction method to reduce the retrieval errors by the online fitting of an 8 order Fourier series. The model and a priori is developed by analyzing the solar calibration measurement. This correction provides a significant improvement to the O A band retrieval. Accordingly, we extend the previous TanSat single CO weak band retrieval to a combined O A and CO weak band retrieval. A Genetic Algorithm (GA) has been applied to determine the threshold values of post-screening filters. In total, 18.3% of the retrieved data is identified as high quality compared to the original measurements. The same quality control parameters have been used in a footprint independent multiple linear regression bias correction due to the stronger correlation with the XCO retrieval error. Twenty sites of the Total Column Carbon Observing Network (TCCON) have been selected to validate our new approach for the TanSat XCO retrieval. We show that our new approach produces a significant improvement on the XCO retrieval accuracy and precision when compared to TCCON with an average bias and RMSE of -0.08 ppm and 1.47 ppm, respectively. The methods used in this study can help to improve the XCO retrieval from TanSat and subsequently the Level-2 data production, and hence will be applied in the TanSat operational XCO processing.