loading page

3D Printed X-band Evanescent Mode Waveguide Filter Based on Pixelization Strategy
  • Jaroslav Zechmeister,
  • Jaroslav Lacik
Jaroslav Zechmeister
Brno University of Technology

Corresponding Author:[email protected]

Author Profile
Jaroslav Lacik
Brno University of Technology
Author Profile


A 3D-printed X-band evanescent mode waveguide filter based on pixelization strategy is proposed in this letter. The uniqueness of the filter lies in the exploitation of the evanescent mode waveguide in conjunction with a 3D-printed dielectric pixelated structure. The crucial advantage of this approach is the fact that the dielectric pixelated structure located in a waveguide is not metal coated, so the fabrication process is easier. The proposed filter is manufactured using the fused deposition modeling 3D print technology. Its measured transmission coefficient in the passband is approximately -2 dB, and the reflection coefficient is below -19 dB.
19 Oct 2023Submitted to Electronics Letters
24 Oct 2023Assigned to Editor
24 Oct 2023Submission Checks Completed
24 Oct 2023Reviewer(s) Assigned
17 Nov 2023Review(s) Completed, Editorial Evaluation Pending
17 Nov 2023Editorial Decision: Revise Major